I managed to pick up a discarded vacuum cleaner quite sometime back. It was a simple vacuum cleaner that had just a flat filter screen between the dust compartment and the motor. Looking at the construction of this vacuum cleaner, […] ↓ Read the rest of this entry…
Posts Tagged wiring
My work table was transported by car from Kuala Lumpur to Butterworth. In order for it to fit into the car, I had to cut off the legs to make it shorter. After it had arrived at its destination, I […] ↓ Read the rest of this entry…
My project for Moving Gantry CNC Machine had hit a snag! Because the moving gantry cnc machine was driven by 2 stepper motors for the x-axis, my full attention was focused on how to connect them from LinuxCNC software configured […] ↓ Read the rest of this entry…
While I was looking at the assembly of the CNC machine from afar, I found that the left side wall was not exactly perpendicular to the movable bed. It was noticeable because the wall was relatively tall, and when viewed […] ↓ Read the rest of this entry…
During my experimentation, I somehow made costly mistake(s) and found that the parallel port installed at my computer was not working properly after one initial successful testing. Subsequent testing were failures. I did not know why and when it occurred. […] ↓ Read the rest of this entry…