Posts Tagged fabricate

3 results.

Vise Repair for Portable Vise

Feb20
by Thomas Yoon Chee Tuck on February 20, 2021 at 9:36 pm
Posted In: DIY

My bench vise had developed a fracture at the base. It was not a good quality bench vise but I would like to try to repair it. Being made of cast iron, I knew that it would be very difficult […] ↓ Read the rest of this entry…

└ Tags: , , , ,
 Comment 

Shaft Pusher instead of Gear Puller

Sep24
by Thomas Yoon Chee Tuck on September 24, 2015 at 10:02 pm
Posted In: DIY

I found a stepper motor not able to turn and would like to dismantle it to service. However, in order to do that, I needed to dismantle both ends of the motor in order to free the motor rotor shaft […] ↓ Read the rest of this entry…

└ Tags: , , , , , , , , , , , , , , , , , , , , ,
 Comment 

Movable Bed CNC machine 4

Aug17
by Thomas Yoon Chee Tuck on August 17, 2015 at 11:49 pm
Posted In: CNC

Watch the video of my testing of 3 stepper motors for the home-made CNC machine. This test was CRUCIAL and could be the most important test that I have done for this project. After having successfully tested the breakout board interface […] ↓ Read the rest of this entry…

└ Tags: , , , , , , , , , , , , , , , , , , , , , , , , , , , , , ,
 Comment